Valve module calibration 306
Tandem / dual scraper setup 307
Tandem scraper 307
Dual scraper 307
Set up 307
Implement setup 308
Prepare connections 308
Primary receiver setup 308
Secondary receiver setup 308
Tandem / Dual settings 308
Tandem / dual calibration 310
WM-Drain setup 311
Implement control settings 312
Valve settings 314
Limit and increment settings 314
Relative heights settings 315
Operation settings 315
Calibrate WM-Drain for cantilever plow 317
Calibrate the valve 321
17 Yield Monitoring setup 323
Yield Monitoring functionality 324
Yield Monitoring best practices 325
Installation 325
Tare calibration 325
Flow calibration 326
Pitch/Roll calibration 326
Test weight 327
Calibrating and operating conditions 327
Yield Monitoring settings 328
Before setup 328
Setup steps 328
Operation settings 329
Crop settings 330
Map settings 331
Sensor output settings 331
Options settings 332
Yield sensor / moisture sensor calibration 333
Calibration steps 333
Speed method 334
Cut width method 335
Third-party display instructions 336
Claas Cebis Quantimeter setup 336
Claas Cebis Quantimeter calibration 337
16 FM-1000 Integrated Display User Guide Version 9.25, Revision B
Contents
To Next Page
Loading...