Trimble FM-1000 - Page 174

Autopilot system 8 Vehicle guidance setup
Slider Bar Direction Sensitivity is... Manual Override is
triggered...
Left Increased More easily
Right
Decreased
Less easily
The value above the slider bar on the right is the current setting. The total range of the slider
bar is 0.5 to 2.5 (where 0.5 is the most sensitive setting and 2.5 is the least sensitive).
4. To try the new setting, tap OK. The Vehicle Calibration screen displays.
5. Select Manual Override again. The Autopilot Manual Override Calibration screen displays again.
6.
Repeat steps 1 through 4 to test each new setting.
Note – You can also evaluate the performance of the manual override feature under conditions of
loading and/or activities which may affect the pressure of the hydraulic system. For example, you can
turn on the auxiliary hydraulics while you evaluate the manual override sensitivity.
7. Tap OK to accept the new setting or tap Cancel to exit.
AutoSense calibration
1. At the Vehicle Calibration screen, select Autosense Calibration and tap OK. The Autopilot AutoSense
Calibration screen displays.
2. From the Location list, select the AutoSense position.
3. From the Orientation list, select the AutoSense orientation.
4. Tap OK to confirm selections.
174 FM-1000 Integrated Display User Guide Version 9.25, Revision B