8 Vehicle guidance setup Autopilot system
Setting Explanation
disengaged.
3.
At the Configuration screen, tap Row Guidance and then tap Diagnostics.
Item Explanation
Offline Distance
Status Status of the sensor
Enable
/
Disable
Tap to enable or disable sensors
Voltage Voltage for the left and right sensor
Voltage status Status for the left and right sensor
Implement setup for Row Guidance
Before starting the Row Guidance setup, ensure that:
l All cables and components of the system are installed on the vehicle.
l The Autopilot system has been installed and configured with the NavController firmware.
l When setting up Autopilot for use with the RG-100 system, ensure that:
ll A vehicle profile that ends in RG-100 is selected at the Vehicle Controller Setup screen
l The XML header file in the latest release of the vehicle database (.vdb) has been added to
the vehicle profiles on the FM-1000 integrated display. Firmware versions after v 6.63
contain an XML file. For instructions on updating the XML file, refer to the support note
Autopilot System: Installing the VDB File (v6) .
l Row Guidance has been added (activated)for the display.
1.
At the Home screen, tap . The Configuration Selection screen displays.
2. Tap Edit next to Implement. The Configuration screen displays.
3. Tap Add/Remove to add Row Guidance to the configuration.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 189
To Next Page
Loading...