Equipment setup 11 ISOBUS setup
For Kverneland:
Type Models Set... VT TC
Spreader Exacta TL
GEOspread
Driving Speed Signal to GPS
J1939.
x x
Task Controller to On.
x
Drill Accord Optima
Precision Drill
Driving Speed to GPS J1939.
x x
Task Controller
to
On
. x
Drill
Monopill SE Driving Speed Signal to GPS
J1939.
x x
Task Controller
to
On
. x
For Rauch:
Type Models Set... Virtual
Terminal
Task
Controller
Spreader AXIS-H-EMC
(40.1 & 50.1)
Task Control to On.
x
GPS Control to On.
x x
VariSpread to On.
x
Change Disc Speed to On.
x
Spreader AXIS-W (40.1 &
50.1)
Manual Speed to the speed
you will drive
x x
GPSC to On.
x
For Vicon:
Type Models Set... Virtual
Terminal
Task
Controller
Spreader RO-EDW
GEOspread
Driving Speed Signal to GPS
J1939.
x x
Task Controller
to
On
. x
3. Refer to the equipment manufacturer's operating instructions for how to change the settings.
4. If you are using the Task Controller, verify that the equipment recognizes it. For more
information, refer to the equipment manufacturer's operating instructions .
254 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...