Trimble FM-1000 - Page 277

14 TrueTracker setup Setup process
Edit vehicle profile
At the Edit Implement Controller screen, change the settings as appropriate.
Choose new vehicle make/model
To select a new make and model from a database of vehicles (.vdb) on the display:
Setting Explanation
Vehicle Profile Location
Select From Database (new).
Model
1. Tap
Browse
and select the required .vdb file.
2. Tap
OK
.
After calibrating a TrueTracker implement NavController, it is
recommended to save the configuration:
1. Tap
Edit
and then Save Implement to file.
2.
Enter the file name and tap OK.
Note –
This is the only method by which to save an implement
TrueTracker NavController configuration.
Choose existing vehicle
To select an existing vehicle from a previously saved file on the display:
Setting Explanation
Vehicle Profile Location
Select From Saved file (existing).
Model
1. Tap Browse and select the required .vdb file.
2. Tap Open.
3.
Tap Change/Restore Implement. The following message displays:
The specified implement model will now be selected on the Autopilot controller.
This will cause the Autopilot controller to be reset. Do you want to continue?
4. Tap OK to load the new configuration. A message displays
information you the Autopilot controller will now be
reinitialized.
5. Tap OK. Read the warnings and tap OK. The file is now loaded.
Change or restore implement
The Change or Restore Implement button is only active when you have selected either a new .vdb or a
saved configuration. Until then it is not available for use.
Version 9.25, Revision B FM-1000 Integrated Display User Guide 277