Implement calibration for TrueTracker system 14 TrueTracker setup
Message: Error - ..... Explanation
Steering Close To End Stops Before the calibration cycle could be completed, the
measured steering angle approached the end stops.
Retry, and if the problem persists, instead of centering
the steering at the start of each cycle, try turning the
steering in the opposite direction to that which is being
tested so that the calibration procedure has a greater
range to test over.
Valve Connectors Could Be Swapped The calibration test sensed the steering turning in the
opposite direction to what was expected. Retry, and if the
problem persists either the valve connectors have been
accidentally swapped or the steering sensor calibration
was performed incorrectly.
No GPS A GPS receiver must be connected and outputting
positions before the software can run the calibration
procedure.
No Steering Response Detected During the calibration cycle, insufficient movement was
sensed in order for the calibration to complete. If the
problem persists, the hydraulic installation could be
faulty.
Unable To Determine DZ: Try Again A problem occurred when trying to compute dead zone.
Retry, and if the problem persists, contact Technical
Support.
286 FM-1000 Integrated Display User Guide Version 9.25, Revision B
To Next Page
Loading...