Trimble FM-1000 - Page 362

Guidance pattern use 18 Operations
ll Shift a swath (page 378)
l Skip a swath (page 379)
A+line creation
To create a straight A+ line:
1. At the Swath Management screen, select the A+ pattern from the pattern list.
2. Enter an access path, if required. See Access paths (page 372).
3.
In the A+ Heading entry box, enter the angle that you want the line to be on or select a previous
AB Line to use its heading.
Note – The default angle is the same as the previous AB Line heading.
4. Tap New Straight. The Run screen displays.
5. Drive to the start of the line and then tap SetA.
6. Tap Use A+. The new A+ line displays.
7. Tap Done.
8.
The system automatically creates the remaining swaths. If you need to shift or skip a swath,
see:
ll Shift a swath (page 378)
l Skip a swath (page 379)
362 FM-1000 Integrated Display User Guide Version 9.25, Revision B