April 2017
6-60
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
dC945, dC980
Launch Issue
General Procedures and Information
dC945 IIT Calibration
Purpose
To perform white reference adjustment, CCD calibration, and optical axis deviation correction
for the scanner.
Procedure
1. Enter Diagnostics, GP 1.
2. Touch dC945 IIT Calibration.
3. Choose the relevant procedure:
• White Reference Adjustment - Side 1.
• CCD Calibration - Side 1.
• Optical Axis Correction.
NOTE: If the machine is positioned directly below a fluorescent light, perform the
optical axis correction procedure with the DADF half lowered. If NG is displayed after
performing the optical axis correction, go to ADJ 60.6.
4. Follow the UI messages.
5. Touch Close.
6. Touch Close to return to the IIT Calibration screen.
7. Touch Back to return to the Diagnostics screen.
dC980 Altitude Adjustment
Purpose
To set the correct altitude for the location of the machine.
Procedure
1. Enter Diagnostics, GP 1.
2. Touch dC980 Altitude Adjustment.
3. Touch the relevant altitude for the machine location.
4. Touch OK.
To Next Page
Loading...
Need help?
General
