April 2017
2-532
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
117-312, 117-313, 117-314
Launch Issue
Status Indicator RAPs
117-312 Machine Self Test Error RAP
117-312 In an OS self program determination test, it was detected that the checksum value
and the mini OS/program were different.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Reload the software, GP 4.
2. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
117-313, 117-314 Geographic Region Change Fail RAP
117-313 The geographic region change command from the PJL can not be implemented.
117-314 The contract type change command from the PJL can not be implemented.
Procedure
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
To Next Page
Loading...
Need help?
General
