April 2017
2-110
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
016-230, 016-232
Launch Issue
Status Indicator RAPs
016-230 License Required (PS Image Log Kit) RAP
016-230 The PS-ROM was installed with ’SW key: Image Log Kit for PS’ in disabled state.
Procedure
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Set the image log kit SW key to ’Enabled’.
016-232 MRC HW Initialize Error RAP
016-232 MRC HW initialize error. an error has occurred during high compression board initial-
ization.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Reload the software, GP 4.
3. Install a new ESS PWB, PL 3.10 Item 6.
To Next Page
Loading...
