Xerox VersaLink B7030 Service Manual

April 2017
4-8
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 1.2, REP 1.3
Launch Issue
Repairs and Adjustments
CAUTION
If the original EEPROM cannot be reused, the feed count, jam count and HFSI count will be
lost.
3. If the EEPROM is damaged during removal and cannot be reused, enter dC131 NVM
read/Write. Enter all NVM settings listed on the NVM Setting List that was supplied with
the machine:
NOTE: The list is located in tray 1, beneath the RAI cover, PL 70.05 Item 10.
4. Ensure that the device ID and billing data is correct, perform dC132.
5. Check the machines current software level against the software level recorded prior to
installation of the new drive PWB. If necessary, reload the software, GP 4.
REP 1.3 LVPS
Parts List on PL 1.10
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Figure 1 ESD Symbol
CAUTION
Observe ESD procedures during this procedure.
1. Remove the upper rear cover, REP 28.5.
2. Remove the lower rear cover, REP 28.6.
3. Disconnect all connectors from the LVPS, Figure 2.
Figure 2 Connectors

Xerox VersaLink B7030 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Resolution	1200 x 1200 dpi
Copy Speed	Up to 30 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Fax Speed	33.6 kbps
Duplex Printing	Automatic
Mobile Printing	Apple AirPrint, Google Cloud Print, Xerox Print Service Plug-in for Android, Mopria
Control Panel	7-inch color touchscreen
Memory	2 GB
Print Speed	30 ppm
Supported Media Sizes	A4, A5, A6, B5, B6, Letter, Legal, Executive
Connectivity	USB, Ethernet, Wi-Fi
Processor	1 GHz
Scan Speed	Up to 55 ipm