Xerox VersaLink B7030

April 2017
4-74
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 12.15
Launch Issue
Repairs and Adjustments
REP 12.15 Stacker Tray Assembly
Parts List on PL 12.06
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the integrated office finisher, REP 12.1.
2. Remove the front inner cover, PL 12.05 Item 6.
3. Remove the rear cover, PL 12.05 Item 14.
4. Turn over the integrated office finisher.
5. Remove the bottom cover, PL 12.06 Item 1.
6. Remove the tray cover, PL 12.06 Item 3.
7. Disconnect the connector, Figure 1:
a. Release the clamp (1).
b. Remove the clamp (2).
c. Release the harness (3) from the retainer.
d. Release the clamp (4).
e. Disconnect the connector (5).
f. Release the harness (6) from the retainer.
Figure 1 Connector
8. Release the wiring, Figure 2:
a. Release five clamps (1).
b. Release the harness (2) from the retainers.
Figure 2 Harness release
9. Remove the stacker sensor assembly, Figure 3:
a. Remove the screw (1).
b. Remove the stacker sensor assembly (2).
c. Release the four clamps (3).
d. Disconnect two connectors (4).
Figure 3 Stacker sensor assembly removal