April 2017
2-64
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
012-210A, 012-211
Launch Issue
Status Indicator RAPs
012-210A NVM Fail RAP
BSD-ON: BSD 3.6 PWB Communications (ESS PWB/Drive PWB to Finisher)
Procedure
NOTE: Ensure the correct RAP is performed, refer to the 012-210 NVM Fail Entry RAP.
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Check the wiring between the finisher and the IOT.
2. If the fault persists, install a new finisher PWB, PL 12.14 Item 1.
012-211 Stacker Tray Fail Entry RAP
012-211 This fault is raised when:
• Within a specified time after the stacker tray started lifting up, the stack height sensor did
not detect the lifting up of the stacker tray.
• Within a specified time after the stacker tray started going down at initialization and during
a job, the lower position of the tray (full) could not be detected based on the changes in
the stacker stack sensor 1 and the stacker stack sensor 2.
Procedure
Go to the relevant procedure:
• Integrated office finisher installed, 012-211A Stacker Tray Fail RAP.
• Office finisher LX installed, 012-211B Stacker Tray Fail RAP.
To Next Page
Loading...
Need help?
General
