Datalogic Magellan 9800i - Page 405

Product Reference Guide 393
Deactivator LED
The tri-color Deactivator LED (item #5 in Figure 58) designates EAS deactivation status (see
Table 17). The table also provides information about special beeper
indications which can be
sounded in response to changes in deactivation status.
Table 17. EAS Indications
EAS DEACTIVATION DISABLED
INDICATION LED DURATION EAS BEEPER COMMENT
Deactivation
Disabled
Deactivation (Tri-color) LED is
OFF
OFF
Deactivation mode
m
ust be selected via
programming. Refer-
ence EAS Mode.
ALL MODES (COUPLED, DECOUPLED, HYBRID or HOST)
Deactivation
Ready
Deactivation (Tri-color) LED is lit
st
eadily Green.
OFF Deactivation is ready.
EAS tag Detected
Deactivation (Tri-color) LED
flashes Red
.
OFF
An EAS tag has been
sense
d in the scan vol-
ume.
Power-up
Initialization
Deactivation (Tri-color) LED
a
blinks ON/OFF Red.
OFF
System is attempting
to ini
tialize EAS
EAS Error
Deactivation (Tri-color) LED
flashes Red whil
e FRU Status LED
flashes error code nine (9)
.
Low frequency beep (1
se
cond)
EAS system is not on
line.
COUPLED MODE ONLY
Deactivation Indi-
cated
Deactivation (Tri-color) LED
f
lashes Red, then Orange, then
returns to Green.
Good read beep follows
deactivation.
The EAS antenna has
been triggered ON to
deactivate a label fol-
lowing successful bar
co
de read.
Manual Deactiva-
tion in Progress
Deactivation (Tri-color) LED is lit
st
eadily Green.
Ticking sound (for con-
figurable duration)
The Manual EAS Deac-
tivation Push Button
was pr
essed &
released
b
.
Manual
Deactivation Suc-
cessful
Deactivation (Tri-color) LED
f
lashes Red, then Orange, then
returns to Green.
High frequency beep
An EAS tag was suc-
cessfully deactivated
v
ia manual push but-
ton.
Deactivate EAS
Sy
stem When
Failed
Deactivation (Tri-color) LED is
flashing slo
wly Red. FRU Status
LED displays error code nine (9)
Upon initiating this state
(pressing EAS Button for
3 seconds): 3 high-
pitched beeps
Upon EAS malfunc-
tion/failure, scanning
func
tion can continue
independent of EAS if
the EAS button is held
for 3 seconds.