204-01-21 Front Suspension 204-01-21
REMOVAL AND INSTALLATION (CONTINUED)
E1060 EN 06/2001 2002 Bantam
10. Remove the suspension unit.
Installation
All Vehicles
1. Position the suspension unit.
2.
CAUTION: Use an Allen key to prevent
the piston rod from rotating.
NOTE: Do not fully tighten the suspension unit
top mount nut.
Install the suspension unit top mount nut.
3. Install the wheel knuckle to the suspension
unit.
1. Install the special tool and rotate through
90 degrees.
2. Install the wheel knuckle.
To Next Page
Loading...
