412-02-7 Heating and Ventilation 412-02-7
REMOVAL AND INSTALLATION (CONTINUED)
E1248 EN 07/2001 2002 Bantam
3. Apply a layer of sealer (see "Materials")
approximately 10 mm thick to the horizontal
top face around the pollen filter opening.
4. Install the remaining components in reverse
order.
Vehicles with air conditioning
NOTE: Before connecting the refrigerant lines,
fit them with new O-rings. Coat the new O-rings
with refrigerant oil before fitting them.
1. Evacuate the air conditioning system and fill
it. For additional information,
refer to Section 412-00.
All vehicles
6. Check the operation of the heating and air
conditioning system (if fitted).
To Next Page
Loading...
