412-03-24 Air Conditioning 412-03-24
REMOVAL AND INSTALLATION (CONTINUED)
5. Remove the bulkhead extension
(continued).
• Remove the single screw.
6. Remove the air conditioning low-pressure
switch.
• Disconnect the plug.
7. By-pass the plug contacts for the air
conditioning low pressure switch.
• Start the engine.
• Switch on the air conditioning.
NOTE: Run the engine at idle for 30 seconds
with the air conditioning switched on before re-
moving the air conditioning low pressure switch.
8. Remove the air conditioning low pressure
switch.
Installation
NOTE: Tightening torques. For additional in-
formation,
refer to Section 412-03. Specifications
E1261 EN 07/2001 2002 Bantam
To Next Page
Loading...
