413-01-17 Instrument Cluster 413-01-17
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
G5: CHECK OPERATION OF PARKING BRAKE SWITCH.
1.
2 Make sure the parking brake is in the ON posi-
tion.
3 Measure the resistance between the parking
brake switch C26 pin 2, circuit 31S-WC18
(BK/RD), and ground.
• Is the resistance less than 5 ohms?
Yes
REPAIR circuit 31S-WC18 (BK/RD). TEST
the system for normal operation.
No
INSTALL a new parking brake switch. TEST
the system for normal operation.
PINPOINT TEST H: THE LOW FUEL WARNING INDICATOR IS INOPERATIVE – FROM 01/99
ONWARDS
CONDITIONS
DETAILS/RESULTS/ACTIONS
H1: TEST OPERATION OF WARNING INDICATOR
NOTE: The low fuel warning indicator is only active when enabled by the module configuration.
1 Select the instrument cluster self-diagnostic
mode test 3 – illuminate warning indicators.
• Does the low fuel warning indicator illuminate?
Yes
GO TO A1
No
INSTALL a new instrument cluster. TEST
the system for normal operation.
E1282 EN 09/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
To Next Page
Loading...
