Ford 2002 Bantam - Page 1324

417-01-8 Exterior Lighting 417-01-8
DIAGNOSIS AND TESTING
Headlamps
Refer to Wiring Diagram Cell: 41701,
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
Electrical
• Fuse(s).
• Bulb(s).
• Wiring harnesses.
• Electrical connector(s).
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Condition Possible Sources Action
• Both headlamps are inoperative.
• Fuse.
• Circuit(s).
• Multifunction switch.
• Central Junction Box (CJB).
• Go To Pinpoint Test A
• The low beams are inoperative.
• Circuit(s).
• Relay – low beam.
• Multifunction switch.
• Go To Pinpoint Test B
• The high beams are inoperative.
• Circuit(s).
• Relay – high beam.
• Multifunction switch.
• Go To Pinpoint Test C
• One low beam headlamp is in-
operative.
• Fuse(s).
• Bulb(s).
• Circuit(s).
• Headlamp, left-hand side / right-
hand side.
• Go To Pinpoint Test D
• One high beam headlamp is
inoperative
.
• Fuse(s).
• Bulb(s).
• Circuit(s).
• Headlamp, left-hand side / right-
hand side.
• Go To Pinpoint Test E
• The Headlamps are on continu-
ously.
• Circuit(s).
• Multifunction switch.
• Relay – low beam.
• Relay – high beam.
• Instrument cluster.
• Go To Pinpoint Test F
• Flash-to-pass feature is inopera-
tive.
• Multifunction switch. • Go To Pinpoint Test G
E9418 EN 07/2001 2002 Bantam
for schematic and connector
information.