Ford 2002 Bantam - Page 1335

417-01-17 Exterior Lighting 417-01-17
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between headlamp,
right-hand side, connector C46, pin 7, circuit
31-LE30A (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, right-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, right-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
D9: CHECK THE POWER SUPPLY OF FUSE F11
1 Measure the voltage between fuse F11 (10 A)
(CJB) and ground.
• Is battery voltage indicated?
 Yes
REPAIR the open circuit(s) between fuse
F11 and headlamp, right-hand side, by
using the wiring diagrams. TEST the system
for normal operation.
 No
REPAIR the open circuit(s) between relay –
low beam and fuse F11, by using the wiring
diagrams. TEST the system for normal op-
eration.
PINPOINT TEST E: ONE HIGH BEAM HEADLAMP IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
E1: DETERMINE THE FAULT CONDITION
1.
2 Turn the multifunction switch to the LOW
BEAM and HIGH BEAM position.
3 Check which high beam headlamp is
inoperative.
• Is the high beam headlamp at the left side
inoperative?
 Yes
GO TO E2
 No
GO TO E6
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL