Ford 2002 Bantam - Page 1337

417-01-19 Exterior Lighting 417-01-19
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between headlamp,
left-hand side, connector C45, pin 6, circuit 31-
LE31 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, left-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, left-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
E5: CHECK THE POWER SUPPLY OF FUSE F21
1 Measure the voltage between fuse F21 (10 A)
(CJB) and ground.
• Is battery voltage indicated?
 Yes
REPAIR the open circuit(s) between fuse
F21 and headlamp, left-hand side, by using
the wiring diagrams. TEST the system for
normal operation.
 No
REPAIR the open circuit(s) between relay –
high beam and fuse F21, by using the wiring
diagrams. TEST the system for normal op-
eration.
E6: CHECK THE FUSE F22
1. 2.
Fuse F22 (CJB)
3 Check the fuse F22 (10 A).
• Is the fuse OK?
 Yes
GO TO E7
 No
INSTALL a new fuse F22. If the fuse blows
again, LOCATE and REPAIR the short cir-
cuit by using the wiring diagrams. TEST the
system for normal operation.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL