Ford 2002 Bantam - Page 1338

417-01-20 Exterior Lighting 417-01-20
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
E7: CHECK THE POWER SUPPLY OF HEADLAMP, RIGHT-HAND SIDE
1.
Fuse F22 (CJB)
2.
Headlamp, right-
hand side C46
3.
4 Turn the multifunction switch to the LOW
BEAM and HIGH BEAM position.
5 Measure the voltage between headlamp, right-
hand side, connector C46, pin 1, circuit 14S-
LE22 (VT/OG), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO E8
 No
GO TO E9
E8: CHECK THE GROUND CONNECTION OF HEADLAMP, RIGHT-HAND SIDE
1.
2 Measure the resistance between headlamp,
right-hand side, connector C46, pin 6, circuit
31-LE30 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, right-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, right-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL