417-01-16 Exterior Lighting 417-01-16
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Check the fuse F11 (10 A).
• Is the fuse OK?
Yes
GO TO D7
No
INSTALL a new fuse F11. If the fuse blows
again, LOCATE and REPAIR the short cir-
cuit by using the wiring diagrams. TEST the
system for normal operation.
D7: CHECK THE POWER SUPPLY OF HEADLAMP, RIGHT-HAND SIDE
1.
Fuse F11 (CJB)
2.
Headlamp, right-
hand side C46
3.
4 Turn the multifunction switch to the LOW
BEAM position.
5 Measure the voltage between headlamp, right-
hand side, connector C46, pin 2, circuit 14S-
LE23 (VT/WH), harness side and ground.
• Is battery voltage indicated?
Yes
GO TO D8
No
GO TO D9
D8: CHECK THE GROUND CONNECTION OF HEADLAMP, RIGHT-HAND SIDE
1.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
