417-01-15 Exterior Lighting 417-01-15
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
D4: CHECK THE GROUND CONNECTION OF HEADLAMP, LEFT-HAND SIDE
1.
2 Measure the resistance between headlamp,
left-hand side, connector C45, pin 7, circuit 31-
LE31A (BK), harness side and ground.
• Is the resistance less than 2 ohms?
Yes
CHECK the headlamp, left-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
No
REPAIR the open circuit(s) between head-
lamp, left-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
D5: CHECK THE POWER SUPPLY OF FUSE F10
1 Measure the voltage between fuse F10 (10 A)
(CJB) and ground.
• Is battery voltage indicated?
Yes
REPAIR the open circuit(s) between fuse
F10 and headlamp, left-hand side, by using
the wiring diagrams. TEST the system for
normal operation.
No
REPAIR the open circuit(s) between relay –
low beam and fuse F10, by using the wiring
diagrams. TEST the system for normal op-
eration.
D6: CHECK THE FUSE F11
1.
2.
Fuse F11 (CJB)
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
