Ford 2002 Bantam - Page 1332

417-01-14 Exterior Lighting 417-01-14
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Check which low beam headlamp is
inoperative.
• Is the low beam headlamp at the left side
inoperative?
 Yes
GO TO D2
 No
GO TO D6
D2: CHECK THE FUSE F10
1. 2.
Fuse F10 (CJB)
3 Check the fuse F10 (10 A).
• Is the fuse OK?
 Yes
GO TO D3
 No
INSTALL a new fuse F10. If the fuse blows
again, LOCATE and REPAIR the short cir-
cuit by using the wiring diagrams. TEST the
system for normal operation.
D3: CHECK THE POWER SUPPLY OF HEADLAMP, LEFT-HAND SIDE
1.
Fuse F10 (CJB)
2.
Headlamp, left-hand
side C45
3.
4 Turn the multifunction switch to the LOW
BEAM position.
5 Measure the voltage between headlamp, left-
hand side, connector C45, pin 2, circuit 14S-
LE16 (VT/OG), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO D4
 No
GO TO D5
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL