Ford 2002 Bantam - Page 1357

417-01-36 Exterior Lighting 417-01-36
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
4 Measure the resistance between multifunction
switch, connector C15a, pin 11, circuit 49-LG2
(BU/RD), harness side and rear turn signal
lamp, left-hand side, connector C66, circuit 49-
LG19 (BU/RD), harness side.
• Is the resistance less than 2 ohms?
 Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between multi-
function switch and splice S35, by using the
wiring diagrams. TEST the system for nor-
mal operation.
K10: CHECK THE RELAY – ANTI-THEFT FLASHER FOR PROPER FUNCTION
1. 2.
Relay – anti-theft
flasher C323
3 Check if the left-hand turn signal lamps are on
continuously.
• Are the left-hand turn signal lamps on
continuously?
 Yes
GO TO K11
 No
INSTALL a new relay – anti-theft flasher.
TEST the system for normal operation.
K11: CHECK THE RELAY – TURN SIGNAL FOR PROPER FUNCTION
1.
Relay – turn sig-
nal
2.
3 Turn the multifunction switch to the LEFT-
HAND TURN SIGNAL position.
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL