Ford 2002 Bantam - Page 1356

417-01-35 Exterior Lighting 417-01-35
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the resistance between relay socket –
turn signal, terminal 49A and multifunction
switch, connector C15a, pin 5, circuit 49-LG1
(BU), component side.
• Is the resistance less than 2 ohms?
 Yes
INSTALL a new relay – turn signal. TEST
the system for normal operation.
 No
INSTALL a new multifunction switch. TEST
the system for normal operation.
K8: CHECK THE CIRCU FOR LEFT-HAND TURN SIGNAL FOR OPEN IT
1. 2.
Multifunction switch
C15a
3.
Rear turn signal
lamp, left-hand side
C68
4 Measure the resistance between multifunction
switch, connector C15a, pin 5, circuit 49-LG1
(BU), harness side and rear turn signal lamp,
left-hand side, connector C68, circuit 14S-
LG12 (BU), harness side.
• Is the resistance less than 2 ohms?
 Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between multi-
function switch and splice S36, by using the
wiring diagrams. TEST the system for nor-
mal operation.
K9: CHECK THE CIRCUIT FOR RIGHT-HAND TURN SIGNAL FOR OPEN
1. 2.
Multifunction switch
C15a
3.
Rear turn signal
lamp, right-hand
side C66
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL