Ford 2002 Bantam - Page 1355

417-01-34 Exterior Lighting 417-01-34
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
K4: CHECK THE GROUND CONNECTION OF MULTIFUNCTION SWITCH
1 Measure the resistance between multifunction
switch, connector C15a, pin 8, circuit 31-LE29
(BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
GO TO K5
 No
REPAIR the open circuit(s) between multi-
function switch and ground G6, by using the
wiring diagrams. TEST the system for nor-
mal operation.
K5: CHECK THE POWER SUPPLY OF RELAY – TURN SIGNAL
1 Measure the voltage between relay socket –
turn signal, terminal 49 and ground.
• Is battery voltage indicated?
 Yes
GO TO K6
 No
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
K6: CHECK THE GROUND CONNECTION OF RELAY – TURN SIGNAL
1 Measure the resistance between relay socket –
turn signal, terminal 31 and ground.
• Is the resistance less than 2 ohms?
 Yes
GO TO K7
 No
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
K7: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION
1 Turn the multifunction switch to the LEFT-
HAND TURN SIGNAL position.
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL