Ford 2002 Bantam - Page 1354

417-01-33B Exterior Lighting 417-01-33B
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Check if the turn signal lamps are on
continuously or inoperative.
• Are the turn signal lamps inoperative?
 Yes
All turn signal lamps: GO TO K2
All left-hand turn signal lamps: GO TO K8
All right-hand turn signal lamps: GO TO K9
 No
All left-hand turn signal lamps are on
continuously: GO TO K10
All right-hand turn signal lamps are on con-
tinuously: GO TO K14
K2: CHECK THE POWER SUPPLY OF MULTIFUNCTION SWITCH
1. 2.
Multifunction switch
C15a
3.
4 Measure the voltage between multifunction
switch, connector C15a, pin 9, circuit 14-LG5
(VT), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO K4
 No
GO TO K3
K3: CHECK THE FUSE F17
1. 2.
Fuse F17 (CJB)
• Is the fuse F17 (15 A) OK?
 Yes
REPAIR the open circuit(s) between fuse
F17 and multifunction switch, by using the
wiring diagrams. TEST the system for
normal operation.
 No
INSTALL a new fuse F17 (15 A). If the fuse
blows again, LOCATE and REPAIR the
short circuit by using the wiring diagrams.
TEST the system for normal operation.
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL