Ford 2002 Bantam - Page 1362

417-01-41 Exterior Lighting 417-01-41
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the voltage between headlamp, left-
hand side, connector C45, pin 3, circuit 49-
LG11 (BU/OG), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO L3
 No
REPAIR the open circuit(s) between splice
S36 and headlamp, left-hand side, by using
the wiring diagrams. TEST the system for
normal operation.
L3: CHECK THE GROUND CONNECTION OF FRONT TURN SIGNAL, LEFT-HAND SIDE
1 Measure the resistance between headlamp,
left-hand side, connector C45, pin 6, circuit 31-
LE31 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, left-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, left-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
L4: DETERMINE THE IN PERATIVE TURN SIGNAL LAMP O
1.
2 Turn the multifunction switch to the LEFT-
HAND TURN SIGNAL position.
3 Determine the inoperative left-hand turn signal
lamp.
• Is the side turn signal lamp, left-hand side
inoperative?
 Yes
GO TO L5
 No
GO TO L7
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL