Ford 2002 Bantam - Page 1363

417-01-42 Exterior Lighting 417-01-42
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
L5: CHECK THE POWER SUPPLY OF SIDE TURN SIGNAL LAMP, LEFT-HAND SIDE
1.
Side turn signal
lamp, left-hand
side C145
2 Measure the voltage between side turn signal
lamp, left-hand side, connector C145, pin 2,
circuit 49-LG13 (BU/RD), harness side and
ground.
• Is battery voltage indicated?
 Yes
GO TO L6
 No
REPAIR the open circuit(s) between splice
S36 and side turn signal lamp, left-hand
side, by using the wiring diagrams. TEST
the system for normal operation.
L6: CHECK THE GROUND CONNECTION OF SIDE TURN SIGNAL LAMP, LEFT-HAND SIDE
1 Measure the resistance between side turn
signal lamp, left-hand side, connector C145,
pin 1, circuit 31-LG13 (BK), harness side and
ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the side turn signal lamp, left-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between side
turn signal lamp, left-hand side and ground
G10, by using the wiring diagrams. TEST
the system for normal operation.
L7: DETERMINE THE INOPERATIVE LEFT-HAND TURN SIGNAL LAMP
1 Turn the multifunction switch to the LEFT-
HAND TURN SIGNAL position.
2 Determine the inoperative left-hand turn signal
lamp.
• Is the rear turn signal lamp, left-hand side
inoperative?
 Yes
GO TO L8
 No
GO TO L10
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL