Ford 2002 Bantam - Page 1364

417-01-43 Exterior Lighting 417-01-43
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
L8: CHECK THE POWER SUPPLY OF REAR TURN SIGNAL LAMP, LEFT-HAND SIDE
1.
Rear signal lamp,
left-hand side C68
2 Measure the voltage between rear turn signal
lamp, left-hand side, connector C68, circuit 49-
LG12 (BU), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO L9
 No
REPAIR the open circuit(s) between splice
S36 and rear turn signal lamp, left-hand
side, by using the wiring diagrams. TEST
the system for normal operation.
L9: CHECK THE GROUND CONNECTION OF REAR TURN SIGNAL LAMP, LEFT-HAND SIDE
1 Measure the resistance between rear turn
signal lamp, left-hand side, connector C68,
circuit 31-LG12 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear turn signal lamp, left-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
turn signal lamp, left-hand side and ground
G4, by using the wiring diagrams. TEST the
system for normal operation.
L10: CHECK THE TURN SIGNAL INDICATOR
1 Actuate the hazard warning switch.
• Is a turn signal indicator inoperative?
 Yes
GO TO L11
 No
GO TO L13
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL