Ford 2002 Bantam - Page 1365

417-01-44 Exterior Lighting 417-01-44
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
L11: CHECK THE POWER SUPPLY OF TURN INDICATOR, LEFT-HAND SIDE
1. 2.
Instrument cluster
C37
3.
4 Measure the voltage between instrument
cluster, connector C37, pin 7, circuit 49-LG15
(BU/BK), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO L12
 No
REPAIR the open circuit(s) between splice
S36 and instrument cluster, by using the
wiring diagrams. TEST the system for nor-
mal operation.
L12: CHECK THE POWER SUPPLY OF TURN INDICATOR, RIGHT-HAND SIDE
1 Measure the voltage between instrument
cluster, connector C37, pin 29, circuit 49-LG22
(BU/YE), harness side and ground.
• Is battery voltage indicated?
 Yes
CHECK the instrument cluster. If necessary
INSTALL a new one. TEST the system for
normal operation.
 No
REPAIR the open circuit(s) between splice
S35 and instrument cluster, by using the
wiring diagrams. TEST the system for nor-
mal operation.
L13: DETERMINE THE INOPERATIVE TURN SIGNAL LAMP
1 Turn the multifunction switch to the RIGHT-
HAND TURN SIGNAL position.
2 Determine the inoperative right-hand turn
signal lamp.
• Is the front turn signal lamp, right-hand side
inoperative?
 Yes
GO TO L14
 No
GO TO L16
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL