Ford 2002 Bantam - Page 1366

417-01-45 Exterior Lighting 417-01-45
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
L14: CHECK THE POWER SUPPLY OF FRONT RIGHT-HAND TURN SIGNAL LAMP
1. 2.
Headlamp, right-
hand side C46
3 Measure the voltage between Headlamp, right-
hand side, connector C46, pin 3, circuit 49-
LG18 (BU), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO L15
 No
REPAIR the open circuit(s) between splice
S35 and headlamp, right-hand side, by us-
ing the wiring diagrams. TEST the system
for normal operation.
L15: CHECK THE GROUND CONNECTION OF FRONT RIGHT-HAND TURN SIGNAL LAMP
1 Measure the resistance between headlamp,
right-hand side, connector C46, pin 6, circuit
31-LE30 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, right-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, right-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
L16: DETERMINE THE INOPERATIVE TURN SIGNAL LAMP
1 Turn the multifunction switch to the RIGHT-
HAND TURN SIGNAL position.
2 Determine the inoperative right-hand turn
signal lamp.
• Is the side turn signal lamp, right-hand side
inoperative?
 Yes
GO TO L17
 No
GO TO L19
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL