417-01-53 Exterior Lighting 417-01-53
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Check the fuse F7 (10 A).
• Is the fuse OK?
Yes
REPAIR the open circuit between fuse F7
and splice S10, by using the wiring
diagrams. TEST the system for normal
operation.
No
INSTALL a new fuse F7. If the fuse blows
again, LOCATE and REPAIR the short cir-
cuit by using the wiring diagrams. TEST the
system for normal operation.
N5: DETERMINE THE FAULT CONDITION
1 Determine the fault condition.
• Is the front parking lamp, left-hand side
inoperative?
Yes
GO TO N6
No
GO TO N8
N6: CHECK THE POWER SUPPLY OF FRONT PARKING LAMP, LEFT-HAND SIDE
1 Turn the multifunction switch to the OFF posi-
tion.
2.
Headlamp, left-
hand side C45
3 Turn the multifunction switch to the PARKING
LIGHT position.
4 Measure the voltage between headlamp, left-
hand side, connector C45, pin 4, circuit 29S-
LF7 (BK), harness side and ground.
• Is battery voltage indicated?
Yes
GO TO N7
No
REPAIR the open circuit(s) between splice
S9 and headlamp, left-hand side, by using
the wiring diagrams. TEST the system for
normal operation.
E9427 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
