Ford 2002 Bantam - Page 1378

417-01-54 Exterior Lighting 417-01-54
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
N7: CHECK THE GROUND CONNECTION OF HEADLAMP, LEFT-HAND SIDE
1 Measure the resistance between headlamp,
left-hand side, connector C45, pin 6, circuit 31-
LE31 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the headlamp, left-hand side. If
necessary INSTALL a new one. TEST the
system for normal operation.
 No
REPAIR the open circuit(s) between head-
lamp, left-hand side and ground G9, by us-
ing the wiring diagrams. TEST the system
for normal operation.
N8: DETERMINE THE FAULT CONDITION
1 Determine the fault condition.
• Is the rear parking lamp, left-hand side
inoperative?
 Yes
GO TO N9
 No
GO TO N11
N9: CHECK THE POWER SUPPLY OF REAR PARKING LAMP, LEFT-HAND SIDE
1.
Rear lamp as-
sembly, left-hand
side C39
2 Measure the voltage between rear lamp
assembly, left-hand side, connector C39,
circuit 29S-LF11 (OG/WH), harness side and
ground.
• Is battery voltage indicated?
 Yes
GO TO N10
 No
REPAIR the open circuit(s) between splice
S9 and rear lamp assembly, left-hand side,
by using the wiring diagrams. TEST the sys-
tem for normal operation.
E9427 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL