Ford 2002 Bantam - Page 1379

417-01-55 Exterior Lighting 417-01-55
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
N10: CHECK THE GROUND CONNECTION OF REAR PARKING LAMP, LEFT-HAND SIDE
1 Measure the resistance between rear lamp
assembly, left-hand side, connector C39,
circuit 31-LF23 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear lamp assembly, left-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
lamp assembly, left-hand side and ground,
by using the wiring diagrams. TEST the sys-
tem for normal operation.
N11: DETERMINE THE FAULT CONDITION
1 Determine the fault condition.
• Is the front parking lamp, right-hand side
inoperative?
 Yes
GO TO N12
 No
GO TO N14
N12: CHECK THE POWER SUPPLY OF FRONT PARKING LAMP, RIGHT-HAND SIDE
1.
Headlamp, right-
hand side C46
2 Measure the voltage between headlamp, right-
hand side, connector C46, pin 4, circuit 29S-
LF16 (OG/GN), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO N13
 No
REPAIR the open circuit(s) between splice
S10 and headlamp, right-hand side, by us-
ing the wiring diagrams. TEST the system
for normal operation.
E9427 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL