Ford 2002 Bantam - Page 1381

417-01-57 Exterior Lighting 417-01-57
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
N16: CHECK THE GROUND CONNECTION OF REAR PARKING LAMP, RIGHT-HAND SIDE
1 Measure the resistance between rear lamp
assembly, right-hand side, connector C42,
circuit 31-LF24 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear lamp assembly, right-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
lamp assembly, right-hand side and ground
G3, by using the wiring diagrams. TEST the
system for normal operation.
N17: CHECK THE POWER SUPPLY OF LICENSE PLATE LAMP
1.
License plate
lamp C40a
2 Measure the voltage between License plate
lamp, connector C40a, circuit 29S-LF12
(OG/BK), harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO N18
 No
REPAIR the open circuit(s) between splice
S10 and license plate lamp, by using the
wiring diagrams. TEST the system for nor-
mal operation.
N18: CHECK THE GROUND CONNECTION OF LICENSE PLATE LAMP
1.
License plate
lamp C40b
E9427 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL