Ford 2002 Bantam - Page 1387

417-01-63 Exterior Lighting 417-01-63
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
Q4: CHECK THE POWE SUPPLY OF REVERSING LAMP R
1. 2.
Reversing lamp
C67
3.
4 Set the transmission in the REVERSE position.
5 Measure the voltage between reversing lamp,
connector C67, circuit 14S-LG36 (VT/BK),
harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO Q5
 No
REPAIR the open circuit between transmis-
sion switch and reversing lamp, by using the
wiring diagrams. TEST the system for nor-
mal operation.
Q5: CHECK THE GROUND CONNECTION OF REVERSING LAMP
1.
2 Measure the resistance between reversing
lamp, connector C67, circuit 31-LG36 (BK),
harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the reversing lamp. If necessary
INSTALL a new one. TEST the system for
normal operation.
 No
REPAIR the open circuit(s) between revers-
ing lamp and ground G3, by using the wiring
diagrams. TEST the system for normal op-
eration.
E6755 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL