Ford 2002 Bantam - Page 1407

418-00-6 Module Communications Network 418-00-6
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the voltage between fuse F2 and
ground.
• Is battery voltage indicated?
 Yes
GO TO E3
 No
REPAIR the power supply of the fuse F2 by
using the wiring diagrams by using the wir-
ing diagrams. TEST the system for normal
operation.
E3: CHECK THE POWER SUPPLY OF THE DATA LINK CONNECTOR
1.
2 Measure the voltage between data link
connector C31, pin 16, circuit 29-PB9 (OG),
harness side and ground.
• Is battery voltage indicated?
 Yes
GO TO E4
 No
REPAIR the open circuit(s) between fuse F2
and data link connector by using the wiring
diagrams. TEST the system for normal op-
eration.
E4: CHECK THE GROUND CONNECTION OF THE DATA LINK CONNECTOR
1.
2 Measure the resistance between data link
connector C31, pin 5, circuit 91-PC3 (BK/BU)
and pin 4, circuit 31-PB9 (BK), harness side
against ground.
• Is the resistance in both measurements less
than 2 ohms?
 Yes
GO TO E5
 No
REPAIR the open circuit(s) between data
link connector and ground G1 or G8, by us-
ing the wiring diagrams. TEST the system
for normal operation.
E9429 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL