205-04-8 Front Drive Halfshafts 205-04-8
REMOVAL AND INSTALLATION (CONTINUED)
E6319 EN 07/2001 2002 Bantam
Installation
1.
CAUTION: Do not damage the oil seal
when inserting the front drive
halfshaft. Use an installation sleeve
on a manual transmission (supplied
with each new oil seal).
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
NOTE: Make sure the snap ring snaps securely
into place.
Install the front halfshaft in the transmission
using a new snap ring.
2. Pull the halfshaft into the wheel hub using
the special tool.
3.
CAUTION: The axle stub nut can be re-
used four times; mark the nut.
NOTE: Do not tighten the axle stub nut yet.
Put on the axle stub nut.
• Insert the washer and screw on the axle
stub nut.
4. Attach the lower suspension arms to the
spindle carriers.
To Next Page
Loading...
