205-04-11 Front Drive Halfshafts 205-04-11
REMOVAL AND INSTALLATION (CONTINUED)
E6365 EN 07/2001 2002 Bantam
4. Detach the lower suspension arm from the
spindle carrier.
5.
CAUTION: The axle stub nut can be re-
used four times. Mark the nut.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Unscrew and remove the axle stub nut and
remove the washer.
• Press the axle stub out of the wheel hub
using a two-legged puller and tie the
halfshaft up using cable ties.
6. NOTE: Do not damage the boot.
Remove the boot.
• Remove and discard the clamping
straps.
• Slide the boot onto the halfshaft.
7. Remove the halfshaft.
• Pull out the front drive halfshaft from the
tripod housing.
To Next Page
Loading...
