205-04-12 Front Drive Halfshafts 205-04-12
REMOVAL AND INSTALLATION (CONTINUED)
E6365 EN 07/2001 2002 Bantam
Installation
1.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
Install the front halfshaft.
• Install the front drive halfshaft into the
tripod joint.
2. NOTE: Do not damage the boot.
Install the boot.
• Slide the boot onto the halfshaft.
• Install new clamping straps and secure
them using the special tool.
3. Pull the halfshaft into the wheel hub using
the special tool.
4.
CAUTION: The axle stub nut can be re-
used four times. Mark the nut.
CAUTION: Do not tighten the axle stub
nut yet.
Put on the axle stub nut.
• Insert the washer and screw on the axle
stub nut.
To Next Page
Loading...
