Ford 2002 Bantam - Page 1478

501-11-6 Glass, Frames and Mechanisms 501-11-6
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
5 Measure the voltage between the passenger
power window control switch C56 pin 3, circuit
33-AJ18 (YE/VT) harness side and ground.
• Is the voltage greater than 10 volts?
 Yes
GO TO B4
 No
REPAIR circuit 33-AJ18 (YE/VT). TEST the
system for normal operation.
B4: CHECK THE UP CIRCUIT VOLTAGE TO THE PASSENGER POWER WINDOW CONTROL
SWITCH
1 Operate the driver side passenger power win-
dow control switch to the UP position.
2 Measure the voltage between the passenger
power window control switch C56 pin 6, circuit
32-AJ18 (WH/VT) harness side and ground.
• Is the voltage greater than 10 volts?
 Yes
GO TO B5
 No
REPAIR circuit 32-AJ18 (WH/VT). TEST the
system for normal operation.
B5: CHECK THE PASSE GER POWER WINDOW MOTOR CIRCUIT FOR CONTINUITY N
1.
2 Measure the resistance between the
passenger power window control switch C56
pin 1, circuit 32-AJ27 (WH/VT) and pin 7,
circuit 33-AJ27 (YE/VT) harness side.
• Is the resistance less than 5 ohms?
 Yes
VERIFY the customer concern
 No
GO TO B6
E9411 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX