501-11-7 Glass, Frames and Mechanisms 501-11-7
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
B6: CHECK FOR CONTINUITY BETWEEN THE PASSENGER POWER WINDOW CONTROL
SWITCH DOWN CIRCUIT AND THE PASSENGER POWER WINDOW MOTOR
1.
Power Window
Motor C107
2 Measure the resistance between passenger
power window control switch C56 pin 7, circuit
33-AJ27 (YE/VT) and the passenger power
window motor C107 pin 1, circuit 33-AJ27
(YE/VT).
• Is the resistance less than 5 ohms?
Yes
GO TO B7
No
REPAIR circuit 33-AJ27 (YE/VT). TEST the
system for normal operation.
B7: CHECK FOR CONTINUITY BETWEEN THE PASSENGER POWER WINDOW CONTROL
SWITCH UP CIRCUIT AND THE PASSENGER POWER WINDOW MOTOR
1 Measure the resistance between passenger
power window control switch C56 pin 1, circuit
32-AJ27 (WH/VT) and the passenger power
window motor C107 pin 2, circuit 32-AJ27
(WH/VT).
• Is the resistance less than 5 ohms?
Yes
INSTALL a new motor. TEST the system for
normal operation.
No
REPAIR circuit 32-AJ27 (WH/VT). TEST the
system for normal operation.
B8: CHECK FOR CONTINUITY BETWEEN THE DRIVER POWER WINDOW CONTROL SWITCH
AND GROUND
1.
2.
Driver Power Win-
dow Control Switch
C55b
E9411 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
