501-11-8 Glass, Frames and Mechanisms 501-11-8
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
3 Measure the resistance between the driver
power window control switch C55b pin 3, circuit
31-AJ9 (BK) harness side and ground.
• Is the resistance less than 5 ohms?
Yes
GO TO B9
No
REPAIR circuit 31-AJ9 (BK). TEST the sys-
tem for normal operation.
B9: CHECK FOR VOLTAGE TO THE DRIVER POWER WINDOW CONTROL SWITCH
1.
2 Measure the voltage between the driver power
window control switch C55b pin 2, circuit 14-
AJ9 (VT/BK) harness side and ground.
• Is the voltage greater than 10 volts?
Yes
VERIFY the customer concern.
No
REPAIR circuit 14-AJ9 (VT/BK). TEST the
system for normal operation.
E9411 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
CONTINUED
BACK TO CHAPTER INDEX
To Next Page
Loading...
