501-11-23 Glass, Frames and Mechanisms 501-11-23
REMOVAL AND INSTALLATION (CONTINUED)
3.
CAUTION: Make sure the window
glass is adequately supported at the
top of the opening.
Remove the hooks
4. Align the window regulator clamp with the
access hole.
5. Attach the window glass to the window
regulator clamp.
6. Adjust the window glass. For additional
information, refer to Door Window Glass
Adjustment. in this section
7. Disconnect the window control switch
electrical connector.
8. Attach the door panel watershield.
9. Install the front door trim panel. For
additional i
nformation,
refer to Section 501-
05.
E6781 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
To Next Page
