501-11-24 Glass, Frames and Mechanisms 501-11-24
REMOVAL AND INSTALLATION
Windshield Glass (42 115 0)
General Equipment
Hot air gun
Direct glazing cutter for bonded glass
Mixer/Application gun
Removal
1. Disconnect the battery ground cable. For
additional i
nformation, refer to Section 414-
01.
2. NOTE: Should the ambient temperature fall
below 10°C heat the cartridges for
approximately 15 minutes by placing them on
a warm radiator, or by using a hot air gun set
at approximately 25°C.
Heat the polyurethane (PU) adhesive if
necessary.
3. Raise the hood.
4. Remove the windshield wipers.
5. Lower the hood.
6. Remove the interior lamp.
E6783 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
To Next Page
Loading...
