501-11-32 Glass, Frames and Mechanisms 501-11-32
GENERAL PROCEDURES (CONTINUED)
5. Make sure the glass is inside the doorframe
outer seal.
6. Lower the glass to the bottom.
7. Standing inside the door, apply rearward
hand pressure on the outside of the window
glass, at the same time raising the glass to
its fully closed position.
8. Tighten the window glass clamp retaining
screws.
9. Attach the door panel watershield.
10. Install the door trim panel. For additional
information,
refer to Section 501-05.
E899 EN 08/2001 2002 Bantam
To Next Page
Loading...
