205-04-20 Front Drive Halfshafts 205-04-20
REMOVAL AND INSTALLATION (CONTINUED)
E5892 EN 07/2001 2002 Bantam
4. Release the clamping straps from the boot.
• Slide the boot onto the front drive
halfshaft.
5.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
CAUTION: Carefully push the wheel
suspension outwards to avoid damage
to the tripod joint (inner joint).
Detach the front drive halfshaft from the
halfshaft joint.
• Pull off the boot and tie up the front drive
halfshaft.
• Remove the grease from inside the joint.
• Open the snap-ring using snap-ring
pliers and hold it open.
• Remove the snap-ring.
Installation
1.
CAUTION: Support the halfshaft. The
inner joint must not be bent at more
than 18 degrees. The outer joint must
not be bent at more than 45 degrees.
NOTE: Make sure the circlip snaps securely into
place.
Install the front drive halfshaft.
• Insert a new snap-ring into the drive
halfshaft joint groove.
• Slide the boot onto the front drive
halfshaft.
• Insert the front drive halfshaft into the
halfshaft joint until the snap-ring engages.
NOTE: Fill level for models with Endura-DE
diesel engines: 40 g on each side.
• Capacity for all other models: 30 g on
each side.
To Next Page
Loading...
